heater vent surrounds on classic
#1
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: swindon
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
heater vent surrounds on classic
how the bloomin hell do u get them off removed center console etc no probs, just cant get the lil vent surrounds on either side of the dash off and also the door handle surrounds? any help would be great, thanks
#2
Scooby Regular
iTrader: (27)
Door handle surronds; pull the front section towards you and it should unclip then slide the cover to the rear of the car to unclip back section and voila its off!
Side vents may just clip in/out but not too sure as never removed em! Try removing glovebox or lower dash trim and looking behind with a torch to see if there are any screws and/or clips??
Side vents may just clip in/out but not too sure as never removed em! Try removing glovebox or lower dash trim and looking behind with a torch to see if there are any screws and/or clips??
#3
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: swindon
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
thanks blu, had a look but no screws to be seen, managed to get them out and the little top ones with a screwdriver and lots of wiggling, there is a lip on one side and a clip on the other , just gunna spray them up now
#6
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: swindon
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
thanks chief its well worth doin if ur interior is as boring as mine. was going to think about spraying the speedo surround but think it may be a bit overkill on the old spray, end up looking like a halfords classic!
#7
Scooby Regular
Join Date: May 2003
Location: dundee
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
looks good,i just done some of mine the other day,same as yours,but i did the whole centre console silver too.
i added a brushed alluminium gauge surround but not too sure about it,i may take it back out,if someone can post a pic for me il show ya.
i added a brushed alluminium gauge surround but not too sure about it,i may take it back out,if someone can post a pic for me il show ya.
Trending Topics
#9
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: swindon
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
i have been tempted to get one as they look well smart, but how on earth do u get the dash out!!! i tried fitting some lockwoods but i couldnt pull it out far enough to get my hand behind it ( and i did take out all the screws before lol )
#10
Scooby Regular
Join Date: May 2003
Location: dundee
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM