NickAdams

iTrader: (5)

I've just recently replaced my standard gearknob with a Momo Race Airleather Aluminium and was wondering if any of you guys (Or gals) has had the following problems:

1. When I fitted the gearknob,the gaiter appears to sit just below the gearknob now and doesn't seem to secure to anything.

2. The 2x "Momo" logos on the aluminium part at the base of the **** I would of thought would line up in the sense that one would point at the driver and one at the passenger.

Am I just being finicky or is this common?

(It's not a problem for me but thought I'd test the water to see if anybody else had this 'problem')

Cheers,

Nick..

Sorry guys - Double posted due to problems with internet connection at work!!!!

[Edited by NickAdams - 10/24/2001 10:07:23 AM]

Andy Hamilton

Hi Nick

This was one of the reasons I didn't go for a momo on my MY01. A friend of mine had the same problem and I thought
it didn't look too good with the gaiter hanging down.
I went for a Nitosport gearknob which has a special 'lip' for the gaiter to fit onto, looks and fits much much better IMHO.
Having said that , many people have fitted the momo gearknob and are happy!

Andy

Phil

Nick

TSL put my MOMO gear **** on when I had my eibachs fitted and lyndsey had a trick to avoid the gaitor dropping

Didn't watch him though

Speak to Paul (Trouser) at TSL I'm sure its not a state secret

Phil

ozzy

Nick,

I've heard of a few people mentioning "glue". Wasn't keen on that myself as I might fancy another change.

You could change the gaiter for one with ties or elastic to keep it in-place.

Graham Goode Racing sell a "Momo gear **** sleeve for gaiter" for £13 http://www.grahamgoode.com/cgi-bin/p...age=gauges.htm

Anyone know what that is?

Stefan

TonyNesta

If its anything like the fitting on the MY98, the sleeve is a metal ring with a lip - it fits inside the bottom of the ****, and the gaiter fits over the lip. Very simple and very effective, if a tad pricey for a tiny metal ring.

Have a look at this


T

[Edited by TonyNesta - 10/24/2001 1:37:14 PM]

Nathan L

Nick

I found a very simple soloution to this problem when I fitted my Air Race leather and aluminium to my MY01.

Go to your local hardware store and buy a 14mm washer. Slide this on over the gearstick and it will sit neatly on top of a lip lower down. Then clip the gaiter over this washer. Once you have screwed on the Gearknob it will hold the gaiter firmly and will not slide up and down.

Its a little tricky and fiddly but works a treat. If you have any problems getting the washer to sit still then a small blob of superglue holds it whilst you do it and can easily be broken off.

Cheers

Nathan

NickAdams

iTrader: (5)

Thanks for all the posts guys.....
Musta been busy in work today cos I forgot to check this post throughout the day

Think I will attempt to do the "Nathan L" fix over the weekend!

Thanks once again guys! (I knew I could rely on you!!!!)

Cheers,

Nick..

LoFi

Brought the momo **** on sat - fitted with Nathan L fix and the job's a good'un. Thanks for that, a magic fix..
Piers LoFi

Nathan L

Glad to help