Has anyone got any Omari Guages?
#1
Scooby Senior
Thread Starter
iTrader: (1)
Join Date: Nov 2000
Location: Wildberg, Germany/Reading, UK
Posts: 9,706
Likes: 0
Received 73 Likes
on
54 Posts
I just got a set of 45mm Omori Guages and a Subaru Dash pod only Subaru do not supply a face plate for this pod but that is not the question.
Have any of you got, seen or used these Guages I have oil temp, oil pres and Turbo. I have the electric version not the mechanical version.
http://www.omorimeter.co.jp
cheers
Steve
Edited because I am stupid and can't read properly
[Edited by Wurzel - 10/17/2002 11:16:35 AM]
Have any of you got, seen or used these Guages I have oil temp, oil pres and Turbo. I have the electric version not the mechanical version.
http://www.omorimeter.co.jp
cheers
Steve
Edited because I am stupid and can't read properly
[Edited by Wurzel - 10/17/2002 11:16:35 AM]
#3
Scooby Senior
Thread Starter
iTrader: (1)
Join Date: Nov 2000
Location: Wildberg, Germany/Reading, UK
Posts: 9,706
Likes: 0
Received 73 Likes
on
54 Posts
Hi AJ
Yes I was talking about them I have edited the name in my post.
I have bought a sheet of perspex and am going to make a pront plate for the pod.
Don't suppose anyone has any fitting instructions for this do they as subaru don't provide any, It may be stupidly easy if you think about it but atthe moment it does not look so straight forward.
Cheers
Steve
Yes I was talking about them I have edited the name in my post.
I have bought a sheet of perspex and am going to make a pront plate for the pod.
Don't suppose anyone has any fitting instructions for this do they as subaru don't provide any, It may be stupidly easy if you think about it but atthe moment it does not look so straight forward.
Cheers
Steve
#4
Steve,
I think the install is pretty straight forward (as far as meter installs get ).
If you have the pod specifically for your car, it should have all the bits and finishers you need...45mm sounds like a DIN pod application, too - if it is from Subaru all the bits should be there, and one would assume some basic instructions would be there, too.
Try this: http://www.omorimeter.co.jp/beginner-e.html
HTH
I think the install is pretty straight forward (as far as meter installs get ).
If you have the pod specifically for your car, it should have all the bits and finishers you need...45mm sounds like a DIN pod application, too - if it is from Subaru all the bits should be there, and one would assume some basic instructions would be there, too.
Try this: http://www.omorimeter.co.jp/beginner-e.html
HTH
#5
Someone had a bunch of instructions for installing meters, but I can't find it (obviously not trying hard enuff ).
Sorry I can't be more helpful - bit tough from this far away...
Sorry I can't be more helpful - bit tough from this far away...
Thread
Thread Starter
Forum
Replies
Last Post