running a 4 ch amp as a bridged 2 way ?
#2
Not bad amps at all.
Definitely worth doing - bear in mind that bridging will slightly raise your noise floor and distortion in the quest for power, but it's what I've done for the past few years: I found the headroom make the bigger difference.
Set the amp to bridged mode - not sure if you'll find that there's switches or something that need changing: some do, some don't. The manual should also tell you where to connect the speakers, and which input is used
You're best off using a scope or a voltmeter and a test tone to set the gains.
Definitely worth doing - bear in mind that bridging will slightly raise your noise floor and distortion in the quest for power, but it's what I've done for the past few years: I found the headroom make the bigger difference.
Set the amp to bridged mode - not sure if you'll find that there's switches or something that need changing: some do, some don't. The manual should also tell you where to connect the speakers, and which input is used
You're best off using a scope or a voltmeter and a test tone to set the gains.
#3
I want as much headroom to give the Morels a good "kicking" !! They tend to like a "good drive" Also if (??!!) I get the enclosures correct I wont realy nead a sub.
Nick, what do you reccon about sealed enclosures mounted to the doors???
Nick, what do you reccon about sealed enclosures mounted to the doors???
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM