Sub Enclosure Software ?
#1
Moderator
Thread Starter
iTrader: (5)
Join Date: Nov 2001
Location: Not all those who wander are lost
Posts: 17,863
Received 0 Likes
on
0 Posts
Anyone know of any good software for desgining sub enclosures ?
Would like something that can work out the enclosure volume from the dimensions that I specify.
Any help would be appreciated.
Thanks.
Would like something that can work out the enclosure volume from the dimensions that I specify.
Any help would be appreciated.
Thanks.
#2
#6
Scooby Regular
Make sure you get your wood/MDF cut properly, I think all of the big DIY stores do it for free if you buy material from them. I just got a load cut perfectly this afternoon and needed to trim some bits due to me thinking I could remember the sizes, so I've ruined two squares I was going to use for the ends and now I have to buy some more. Stupid me.
Steve.
Steve.
Thread
Thread Starter
Forum
Replies
Last Post
hardcoreimpreza
Computer & Technology Related
21
11 October 2015 03:40 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM