Kenwood radio won’t tune in?
#1
Kenwood radio won’t tune in?
Just fitted my Kenwood head unit in MY04. Have to say not the best end result as it’s one where the front is motorised and you can see the workings ever side of the facia, but there’s no room to put the surround on……
Anyway, it won’t tune in? Any ideas? And yes I have checked that I plugged in the aerial!
Cheers
Chris
Anyway, it won’t tune in? Any ideas? And yes I have checked that I plugged in the aerial!
Cheers
Chris
#4
No, it's on the standard ISO connector. The blue wire, which is amp power/remote turn on, needs to be left connected into the ISO connector as it was when you got it...
From your PM, it sounds like you've disconnected this and are using it to turn on your amps - if that's what's been done, that's your problem
From your PM, it sounds like you've disconnected this and are using it to turn on your amps - if that's what's been done, that's your problem
#5
Scooby Regular
Join Date: Feb 2005
Location: Birmingham
Posts: 1,640
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by CJRH
Just fitted my Kenwood head unit in MY04. Have to say not the best end result as it’s one where the front is motorised and you can see the workings ever side of the facia, but there’s no room to put the surround on……
Anyway, it won’t tune in? Any ideas? And yes I have checked that I plugged in the aerial!
Cheers
Chris
Anyway, it won’t tune in? Any ideas? And yes I have checked that I plugged in the aerial!
Cheers
Chris
Mind I did the same thing as what you may have done, connected everything up refited the facia and the surround around the headunit, powered it up and no radio signal
Had to remove it all and found I hadn't connected the aerial lead to the head unit
All working fine now, and looks the dog nuts
Mark
Thread
Thread Starter
Forum
Replies
Last Post