subaru idle air control valve removal 04 wrx
22 March 2013, 12:37 AM
#1
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Oct 2006
Location: midlands
Posts: 2,316
Likes: 0
Received 0 Likes
on
0 Posts
subaru idle air control valve removal 04 wrx
anyone know the correct size star bit to remove the idle air control valve out off the alloy body itself ,t15 seems too small .
04 wrx
any help or links to tool would be great
04 wrx
any help or links to tool would be great
22 March 2013, 03:02 PM
#4
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Oct 2006
Location: midlands
Posts: 2,316
Likes: 0
Received 0 Likes
on
0 Posts
cheers yeah i know about the gasket. its not those screws i am trying to remove there is
s two star bit screws holding the valve itself into the alloys casing.
s two star bit screws holding the valve itself into the alloys casing.
22 March 2013, 05:39 PM
#5
Scooby Regular
Join Date: May 2008
Location: Warrington
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Ah I see. I used a hacksaw to cut a slot in each screw, can then use a flat blade driver, if I remember correctly the screws used are a 5 point screw, pentalobe I think they are called.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM
