2.2 cosworth stroker kit
11 March 2013, 09:39 PM
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Jan 2011
Location: farnborough, hampshire
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
2.2 cosworth stroker kit
Hi guys looking at a few options for an engine build for about 500 bhp And come across a cosworth 2.2 stroker has anyone had experience with this kit cheers james
11 March 2013, 10:17 PM
#2
Hi James
If you are thinking to run 500bhp I would go with custom 2.1L which can at the end cost lot less than Cosworth stroker kit
Just contact Advanced Automotives or here MartynJ@ET about the pricing on the rods,pistons combo,you can find somewhere else cheaper crank etc.
I would go down the route:
SCBD(Open Deck should be enough too at this level,just depends how much boost you will be running)
Mahle pistons(not sure if Cosworth doing again 2.1L pistons)
Manley or K1 rods
11mm ARP headstuds(Cosowrth 11mm 260k psi headstuds)
ACL race bearings
Cosworth HG
Jura
If you are thinking to run 500bhp I would go with custom 2.1L which can at the end cost lot less than Cosworth stroker kit
Just contact Advanced Automotives or here MartynJ@ET about the pricing on the rods,pistons combo,you can find somewhere else cheaper crank etc.
I would go down the route:
SCBD(Open Deck should be enough too at this level,just depends how much boost you will be running)
Mahle pistons(not sure if Cosworth doing again 2.1L pistons)
Manley or K1 rods
11mm ARP headstuds(Cosowrth 11mm 260k psi headstuds)
ACL race bearings
Cosworth HG
Jura
Thread
Thread Starter
Forum
Replies
Last Post
