anyone used cold air duct for turbo inlet?
12 February 2013, 04:11 AM
#1
anyone used cold air duct for turbo inlet?
so was looking at some of this cold air ducting that most use for air feeds throug fog cover etc to wing filter and so n.
what about using this as the actual turbo inlet hose! if a decernt strong enough one was to be used with good anti suck/crushing strength then why not? as can shape it as it needs to be under the inlet!.
i notice on the ONE OFF MODS thread in the gallery showing off one off jobs someone has done with with a white blobeye? need more feedback as this could be a good option for me. and port less is fine running catch tank!
Grant
what about using this as the actual turbo inlet hose! if a decernt strong enough one was to be used with good anti suck/crushing strength then why not? as can shape it as it needs to be under the inlet!.
i notice on the ONE OFF MODS thread in the gallery showing off one off jobs someone has done with with a white blobeye? need more feedback as this could be a good option for me. and port less is fine running catch tank!
Grant
12 February 2013, 06:24 AM
#2
used a good spec one of these for a cold air feed on my old bug sti and the hose itself was lined with steel wire and proably stronger than a silicone inlet hose, so perhaps i should try this route but ideas and and actual experience doing this from someone would be great!
Thread
Thread Starter
Forum
Replies
Last Post
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM
