Many thanks again to Andy K Chester Le Street... Tidy work as always.

Car gets remapped on the 11th for the final time this year, spec below. Looking for 401hp.

Forced Performance STI Green Turbo with Billet wheel
Perrin Turbo Blanket
Perrin radiator Shroud
HRC 340 fuel pump
DeatschWerks 750cc injectors
Lightened Pulley Kit
76mm RCM Samco turbo inlet
9mm Manifold Spacers
Full 2.5 s/s Prodrive Decat exhaust system
RCM headers & Venturi up pipe / DEI Wrapped
Process West TMIC & Pipework
Inner wing induction kit with 9" K&N Filter
3 port Prodrive BCS,
Exedy clutch
Oil catch tank.
Ecutek Re-map By Bob Rawle (Again)

 

Fair play, all on a WRX lump?

 

Why are you using a venturi up-pipe?
I'd have thought one of Harvey's trick up-pipes would have done the job?

 

STI block.

Didnt have time for uppipe. Maybe in the spring.

 

Recently been a thread on here with not only lower revs spool but more torquer and even more bhp...

My own 2.5 with one, and tubular headers, plus an HS TD05 20g makes 1 bar at around 3200 rpm.

 

Just back from remap with Bob Rawle / Andy K Durham.

Made 401....

Happy.

 

I am surprised it made that with a 2.5inch system but happy days

 

I was going to say with 2.5 exhaust that would be impressive!

 

surprisingly you expected 401 and you got 401!

 

just checked out your new turbo, one I havent seen on here before.

Forced Performance STI Green Turbo with Billet wheel

 

I **** you not...... Made 401 on the nose, co-inkidink..

Andy Forrest made much heigher with a 2.5 inch system.. nowt wrong with 2.5.

Turbo is from the US, works just fine.

Just bought Harvey uppipe and will be fitting soon.