spartagates

iTrader: (1)

Got a 3" japspeed full decat off these boards, was promised gaskets and bolts but very much let down by the seller

Question is would I get away with using liquid gaskets on the install, or should I go the extra mile and try and source the proper gaskets? I have emailed japspeed to see if they sell them separate; any other suggestions of where to source them and expected price would be gratefully received!

barnshaw

iTrader: (1)

surely they are just normal 3inch gaskets? either way you should use proper gaskets

JDM_Stig

iTrader: (3)

as said, your local motor factors will have 1, if you have the original and then measure the size you need of your exhaust, tell them that and they will sort you.

the_baz

I got some off eBay very cheep. I've also used high temp silicon which also done the job very well

the_baz

But don't use silicon before the cat

spartagates

iTrader: (1)

Do you have a link to a similar set that I could look at m8?

Cheers

JohnD

iTrader: (5)

Yes, don't use a silicon based sealant up-stream of any sensors.

JohnD