v3 tmic what power will it do
25 September 2012, 10:00 PM
#1
BANNED
Thread Starter
iTrader: (5)
Join Date: Nov 2009
Posts: 1,279
Likes: 0
Received 0 Likes
on
0 Posts
v3 tmic what power will it do
1 have a v1 wrx looking for some more power .got a td05 440 injectors and bean told to put a fmic .but i would like to keep top mount .bean offered a v3 top mount what power will it do
27 September 2012, 06:51 AM
#5
Only FMIC.
If you want a TMIC go for one off an STi 8 etc. It is a lot of work to fit it to your car properly. it is only a partial solution. Better than what you have now but not the full answer and by the time you have it, have it fitted with taller scoop and under tray it is going to cost you a fair bit. Without scoop and undertray you are wasting your time as I found out.
A direct comparison, back to back. The above car mapped on STi 8 TMIC. 392 bhp all done. Temps high 40s on the rollers.
Hybrid GT (not GT2) fitted, mapped, same mapper, Steve Simpson, same rollers on a day with slightly higher ambient temperature. 401 bhp out the box. 410 after mapping left safe in daily running trim. Temps low 30s.
If you want a TMIC go for one off an STi 8 etc. It is a lot of work to fit it to your car properly. it is only a partial solution. Better than what you have now but not the full answer and by the time you have it, have it fitted with taller scoop and under tray it is going to cost you a fair bit. Without scoop and undertray you are wasting your time as I found out.
A direct comparison, back to back. The above car mapped on STi 8 TMIC. 392 bhp all done. Temps high 40s on the rollers.
Hybrid GT (not GT2) fitted, mapped, same mapper, Steve Simpson, same rollers on a day with slightly higher ambient temperature. 401 bhp out the box. 410 after mapping left safe in daily running trim. Temps low 30s.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM