Coolant bleeding on a 1996 WRX?
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2012
Location: North Wales
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Coolant bleeding on a 1996 WRX?
Hey guys n' gals,
Last week end, when checking my 'new' car, I noticed the coolantdidnt have any antifreze in it and Mr Weatherman was forcasting -19 degrees! So I quickly changed the coolant, drining the old out and putting new in.
Since then however she's not been startign well from cold and somone sugested it's because there's an air lock round the temperature sensor so the car doesnt know to apply the auto choke.
so jsut to rule this out can somone please tell me the correct way to bleed the system on a 1996 WRX? I followed a 'how to' I found on google but I'm not sure it was for the right year.
Solouko
Last week end, when checking my 'new' car, I noticed the coolantdidnt have any antifreze in it and Mr Weatherman was forcasting -19 degrees! So I quickly changed the coolant, drining the old out and putting new in.
Since then however she's not been startign well from cold and somone sugested it's because there's an air lock round the temperature sensor so the car doesnt know to apply the auto choke.
so jsut to rule this out can somone please tell me the correct way to bleed the system on a 1996 WRX? I followed a 'how to' I found on google but I'm not sure it was for the right year.
Solouko
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM