Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Air con not working

Thread Tools
 
Search this Thread
 
Old Aug 18, 2011 | 04:33 PM
  #1  
P4UL's Avatar
P4UL
Thread Starter
Scooby Regular
iTrader: (1)
 
Joined: Aug 2009
Posts: 275
Likes: 0
From: East Lothian
Default Air con not working

Needing a bit of help before resorting to paying garage bills.

As above the air con is not working.
When I switch it on the electromagnetic clutch on the pump is not engaging, no click, no rev drop at idle, nothing at all.

Following checks have been done:

System Gas - ok
Fuse inside car - ok
Relays in engine bay - ok

Is there anything I have missed, or any other electrical checks I can do.

Cheers
Reply
Old Aug 18, 2011 | 04:39 PM
  #2  
leeturbo2000's Avatar
leeturbo2000
Scooby Regular
iTrader: (7)
 
Joined: Dec 2009
Posts: 522
Likes: 0
From: manchester,england
Default

Subbed, same boat lol does your switch turn green( mine does)
Reply
Old Aug 18, 2011 | 04:46 PM
  #3  
P4UL's Avatar
P4UL
Thread Starter
Scooby Regular
iTrader: (1)
 
Joined: Aug 2009
Posts: 275
Likes: 0
From: East Lothian
Default

No mines is an 08 sti, the orange light comes on, but no click from the pump!!!
Reply
Old Aug 18, 2011 | 05:47 PM
  #4  
andy97's Avatar
andy97
Scooby Regular
iTrader: (1)
 
Joined: Aug 2004
Posts: 6,296
Likes: 118
From: Api 500+bhp MD321T @91dB Probably SN's longest owner of an Impreza Turbo
Default

Have you checked the ECU. I know its a silly question, but I have a Simtek ECU and the Aircon became disabled in the menu. The mapper toggled the function aircon worked again. I had all the checks done aswell.

I tracked down that the signal from the ECU wasnt active.

From memory I think its is grounded for aircon to work. I grounded the wire and the solenoid activated indicating the ECU wasnt doing its bit.

Hope this helps. Quite difficult to trace the wiring but it did help me for my problem.

Andy
Reply
Old Aug 18, 2011 | 08:04 PM
  #5  
rob84's Avatar
rob84
Scooby Regular
iTrader: (5)
 
Joined: Jun 2006
Posts: 5,287
Likes: 12
From: somewhere out there
Default

How do you know there is enough gas in the system mate ?? have you had gauges plugged into the ports as this is the only true way to tell.
Reply
Old Aug 18, 2011 | 08:11 PM
  #6  
P4UL's Avatar
P4UL
Thread Starter
Scooby Regular
iTrader: (1)
 
Joined: Aug 2009
Posts: 275
Likes: 0
From: East Lothian
Default

Is there a low pressure switch that would prevent the pump operating?
Reply
Old Aug 18, 2011 | 08:46 PM
  #7  
dunx's Avatar
dunx
Scooby Senior
iTrader: (3)
 
Joined: Jun 2006
Posts: 14,333
Likes: 0
From: Slowly rebuilding the kit of bits into a car...
Default

Yes !

Mine wore through a pipe ( since replaced ) and haven't had time to get it re-filled yet.

HTH

dunx
Reply
Old Aug 18, 2011 | 08:47 PM
  #8  
archer935's Avatar
archer935
Scooby Newbie
 
Joined: Jun 2010
Posts: 27
Likes: 0
Default

if you have less than the minimun pressure in the air con system it may not operate as some systems dont operate if the r134a gas is low. some have a system where they dont run all the time, its an on off system. youve done the main checks, the others you can do is wiring checks from the compressor to the air con switch wiring connector. if the continuety is bad (high ohm reading) then there is a damaged wire. the pump internals (pistons) may have failed but without putting an air con machine on it to check for correct pressure you may need to spend some pennies. just be careful when messing with air con systems if not qualified as you can get fined. hope you sort it out
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
34
Nov 7, 2024 04:10 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
Dec 14, 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
Oct 22, 2015 06:12 AM
Bazil_SW
Engine Management and ECU Remapping
24
Sep 21, 2015 11:55 PM




All times are GMT +1. The time now is 06:32 AM.