95wrx wagon code 35 showing Canister purge solenoid or circuit what and were is it??
#1
95wrx wagon code 35 showing Canister purge solenoid or circuit what and were is it??
Please help as I haven't a clue wot or where it is. I had my chipped ecu in and it kepted going into limp mode so I have put my standard ecu in and its brought code 35 up? Please help thanks
#2
it this any help to you mate
http://forums.nasioc.com/forums/show....php?t=1555499
located drivers side turret above the boost sellunoid.
http://forums.nasioc.com/forums/show....php?t=1555499
located drivers side turret above the boost sellunoid.
#4
As far as i understood it, the 95 WRX (NOT UK Model) DOESNT have the canister purge solenoid, its only the uk model that does
I know this as i fitted a UK ecu to my WRX and had the same fault code,after alot of searching,found out the above,even if you look within the charcoal canister lines,you wont see the solenoid,yet,on a uk model you will see it
so,unless your standard ECU is the wrong one ????
I know this as i fitted a UK ecu to my WRX and had the same fault code,after alot of searching,found out the above,even if you look within the charcoal canister lines,you wont see the solenoid,yet,on a uk model you will see it
so,unless your standard ECU is the wrong one ????
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM