Need a remap! But where??
#1
Scooby Regular
Thread Starter
Join Date: Jan 2011
Location: Nottingham
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Need a remap! But where??
I keep asking around for places to take my car for a remap and i'm hearing good and bad stuff about all places. Does anyone know a good place in the midlands to go?
#2
#9
Scooby Regular
Thread Starter
Join Date: Jan 2011
Location: Nottingham
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Not sure about what the different types of map are? I've been told that cuz it's had manifold, de cat and full stainless that it needs to be mapped to it. I basically want it mapping to be running safe with the equipment i have on it and more power obviously. lol
#10
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
THe best mappers use Ecutek software as it's a professionally supported and developed package, but knowledge and use isn't cheap.
Richard Bulmer and JGM have mapped mine with superb results.
Open Source mappers can do it at a lower cost, the choice is yours.
IMHO.
dunx
Richard Bulmer and JGM have mapped mine with superb results.
Open Source mappers can do it at a lower cost, the choice is yours.
IMHO.
dunx
Thread
Thread Starter
Forum
Replies
Last Post
spudboytim
Other Marques
10
26 September 2015 01:19 PM
charlesr
Engine Management and ECU Remapping
7
26 September 2015 10:46 AM