which 3 bar map sensor do i need?
#6
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
what boost are you planning to run / is the engine setup to take?
It is unusual to exceed the standard map sensor (circ 1.7bar) unless big setup etc
Simon
It is unusual to exceed the standard map sensor (circ 1.7bar) unless big setup etc
Simon
Trending Topics
#8
Ecu Specialist
The std sensor is good for 1.8 bar, you don't really need more if you have a std engine as thats more than enough. if you have or are planning a big build then even the 3 bar sensor is not really not enough, I would then look at a four bar. BTW the specs are always minus one bar and plus whatever is left, so a 3 bar sensor is capable of linearly reading plus 2 bar.
The oem sensor up to and including MY04 can read plus 1.8 bar, new age sensors after that will read a bit more.
So as Simon mentions what are you trying to do with what spec engine?
cheers
bob
The oem sensor up to and including MY04 can read plus 1.8 bar, new age sensors after that will read a bit more.
So as Simon mentions what are you trying to do with what spec engine?
cheers
bob
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM