95 sti not turning over after full rebuild?
#1
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
95 sti not turning over after full rebuild?
hi, ive just finnished putting everything back on a bare shell, on trying to start it for the first time, it wont turn over,
on turning the key to the ignition (lights on dash) the fuel pump kicks in but turning it to the start position there is only a click from a relay in the rear, no starter motor noise at all,
ive checked all fuses in both boxes and there ok,
please please please throw some suggestions my way, im stumped.
thanks, phil.
on turning the key to the ignition (lights on dash) the fuel pump kicks in but turning it to the start position there is only a click from a relay in the rear, no starter motor noise at all,
ive checked all fuses in both boxes and there ok,
please please please throw some suggestions my way, im stumped.
thanks, phil.
#5
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
that was fast, the battery has a full charge but i forgot about smacking the starter, and i will check the earths, i bet it will be one of them as its had a full respray,
is there any more earths than:-
2 either side of the front chassie
1 near the wiper motor
1 the other side of the engine bay
2 under the drivers seat
and 1 in the boot
???
is there any more earths than:-
2 either side of the front chassie
1 near the wiper motor
1 the other side of the engine bay
2 under the drivers seat
and 1 in the boot
???
#7
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
oh yes, sorry, there is one on the right hand side of the inlet, ive also put 2 more from the engine to the body, i forgot about them, is there any more small earths?
Trending Topics
#10
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
yes i tested the spade end that plugs on the starter motor, ill start another thread for the starter relay, thanks very much but anymore help would be good on this thread, thanks phil.
#11
Scooby Regular
Thread Starter
Join Date: Jan 2007
Location: in the engine bay
Posts: 909
Likes: 0
Received 0 Likes
on
0 Posts
ive just realised that the loom i put back on didnt plug into the gearbox, the loom has 2 plugs and the gearbox has one plug so i left it off untill i can sus it out,
is there a switch in the gearbox that lets it know its in neutral?
is there a switch in the gearbox that lets it know its in neutral?
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM