Alignment tool for exedy twin clutch
#1
Alignment tool for exedy twin clutch
Hi guys,
Can someone point me in the right direction were I can buy the right Alignment tool that will work with the exedy twin plate clutch for a Subaru.
Any help would be appreciated.
Can someone point me in the right direction were I can buy the right Alignment tool that will work with the exedy twin plate clutch for a Subaru.
Any help would be appreciated.
#3
I wish I had a old gearbox input shaft ppg box now.
Anyone know the dai size of the alignment tool because I might be able to buy something for the job, just knowing what the dia size is would be helpful.
I never get any joy from this forum
Last edited by magicseven; 10 October 2010 at 07:01 AM.
#4
Scooby Regular
iTrader: (2)
Join Date: Feb 2010
Location: Colchester,Essex
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
make one....
....When iv been doin clutches at home before and not had my alignment tool i usually nick one of my mums wooden spoons, cut the spoon end off and wrap some electrical tape around the necessary areas!! never let me down lol
....When iv been doin clutches at home before and not had my alignment tool i usually nick one of my mums wooden spoons, cut the spoon end off and wrap some electrical tape around the necessary areas!! never let me down lol
#6
Former Sponsor
Join Date: Dec 2005
Location: 10.68 QT mile in 2007 2.33 Type R ** Current 2002 Spec C 2.33 Track prepped.
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
As above input shaft from a breakers or the alignment tool that should come with the clutch when new. Making a spline tool can work if you’re stuck, but I wouldn’t suggest this for a twin plate set up, you may be there for some time.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
speedrick
Subaru Parts
0
26 September 2015 03:01 PM