Alignment tool for exedy twin clutch
 

Hi guys,

Can someone point me in the right direction were I can buy the right Alignment tool that will work with the exedy twin plate clutch for a Subaru.


Any help would be appreciated.

Get hold of an old gearbox input shaft, and cut it to a suitable length.

Perfect clutch alignment tool ;)

.

I wish I had a old gearbox input shaft ppg box now.

Anyone know the dai size of the alignment tool because I might be able to buy something for the job, just knowing what the dia size is would be helpful.
I never get any joy from this forum :rolleyes:

make one....

....When iv been doin clutches at home before and not had my alignment tool i usually nick one of my mums wooden spoons, cut the spoon end off and wrap some electrical tape around the necessary areas!! never let me down lol

eyes are the best tools!!!
:thumb:

As above input shaft from a breakers or the alignment tool that should come with the clutch when new. Making a spline tool can work if you’re stuck, but I wouldn’t suggest this for a twin plate set up, you may be there for some time.

Yes have been there for some time already lol. if you don't line the clutch plates up correctly you can get some vibrration in clutch I believe.....

If you don't align the splines in the two friction plates with each other, you can damage the splines by trying to force the motor onto the input shaft/gearbox.

To much investment in my motor to force something on everything got to be perfect.

Whereabouts are you? - If you're local to me, you can borrow an input shaft :)

Do you mean borrow my car fella lol,,

We have them here for £9.99 if needed.

Tel: 01462 488244.

We have them here for £9.99 if needed.

Tel: 01462 488244.

I got old gearbox shaft cheers fellas lol.