fieldy1978

Hi all some may recognise me as having the rebuild that wont start. I changed the crankshaft sprocket and wanted to fire so bad. My mate towed me today and fired straight away but would only rev to 3000 revs and sounded like wasnt running on all cylinders. pulled over and tried to rev it more but it started to rev harder about 3500-4000 then dropped oil all over the floor so had to shut it down. Guessing its to do with back pressure but any other ideas?And as to what could cause it?

Cheers Spen

fieldy1978

No one have any ideas?Splitpin???

merlin24

iTrader: (1)

Oil Filter leaking ???

Mick

fieldy1978

No it felt asthough there was a lot of back pessure and not jacked it up yet but guessing its blown the rear crank seal out!Gonna climb under this afternoon to see what damage i have done!

STI_Baly

iTrader: (23)

Not to sure about the oil but are you sure you have the right crank sprocket for the car? as they do vary.

fieldy1978

Yeah was identical mate i marryed them up against each other. But sounded like the timing wasn't right but its spot on! I even removed the belt and refitted just to be sure and it's spot on 100%.