5 Door Boot Lid Rattle
#1
My boot lid rattles where the lock meets the metal bar. I have tried grease, adjusting the rubber sealing to tighten the pressure but to no avail. Is there any way to adjust the locking mechanism as the rubber blocks that normally allow adjustment on other cars are fixed so can't be moved. It is starting to get on my T1T5.
Don't suggest stereo volume or decats coz I've done that.
Thanks
Jerome
Don't suggest stereo volume or decats coz I've done that.
Thanks
Jerome
#2
the technical instrument is called a hammer ( i aint joking) there are some adjusting bolts under the trim i think for the metal bar try these first if they dont go enough give it a couple of good hits that should then work
by the way thats not recommended by subaru
by the way thats not recommended by subaru
#4
I had the same problem on my 5 door. I tried adjusting the metal loop as there are two bolts that attach it to the back of the car but I still got a rattle. In the end I elongated the holes in this bracket so it meant you could bolt it further down. ie the bracket is closer to the floor so it makes the bootlid shut tighter. This eventually cured my rattle. Hope this makes sense and helps.
Stuart
Stuart
Trending Topics
#9
James
Yes thats what I did but I didnt use the hammer. I used a file/drill to elongate the holes so the bracket could be bolted further down making the tailgate shut tighter to the rubber.
Stuart
Yes thats what I did but I didnt use the hammer. I used a file/drill to elongate the holes so the bracket could be bolted further down making the tailgate shut tighter to the rubber.
Stuart
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM