Beastra

iTrader: (20)

My inlet manifold will be off next week so that the inlet pipe can be replaced so might as well do the parellel fuel rail mod, fit an adjustable FPR and gauge, and put an oil catch tank in as well.

I`m currently trying to find a UK company that can supply a set of billet (or similar) fuel rails and fittings for a phase 1.5 manifold/V3-V4 but have only found Slow boy racing, and they only have the V5-V6 rails now. Does anyone know where I can buy some V3-V4 billet rails in the UK as I would need them for the middle of next week.


Oil Catch Tank

I`m looking at buying this oil catch tank and was wondering if I need the 10mm or 15mm version.

D1 Spec 15mm Oil Catch Tank Red Universal on eBay (end time 11-Oct-09 12:41:37 BST)

Also, which of the outlets in the inlet pipe below will need to be blanked off when the oil catch tank is installed. Just so that I can sort out some blanking plugs in advance to the car going in next week.



Any help would be very much appreciated as always.

dunx

iTrader: (3)

Isn't Carl Davey "the man" ?

Mine's a breather delete inlet so all mine are re-routed...

dunx

Beastra

iTrader: (20)

The one`s Carl Davey sell are only for phase 2 injectors or aftermarket injectors.

cushti

iTrader: (7)

Try mocomracing.com - they do them exch for £100. They're not billet, just ends converted to -6an.

Go for 15mm for the catch can. Most only come with two outlets - I got another outlet tapped in so I could keep the rockers & crank breather separate.

wrighty338

iTrader: (33)

il say try harvey smith i got my v5 rails from there and theyre snazzy - theyre reaaal similar to the ones you see on ebay for cheaper though..

iv just re-fitted my inlet + rails and a viper performance inlet tract and all im going to say is, my inlet tract is a really bad fit - infact im glad il be blanking all but one of the vacuum take offs because they nearly all foul things on the inlet manifold - be warned!

dont pay £50 for one of them catch tanks either theres loads on ebay non-branded and theyre all come from the same factory! youl save £20 notes easy. youl need 15mm - perhaps worth investing in 2 15mm breather filters too - put these on the rocker breathers and use the catch can on the crank breather - the main offender of oily vapour! you can also block the PCV on the inlet manifold too if you like.

boylejohnstone

roger clark does a excellent breather system with fittig kit for £250 also carl davey does a billet fuel rail that fits the phase 1.5 manifolds