which position for the oil temp/pressure
23 September 2009, 03:16 PM
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Aug 2006
Posts: 448
Likes: 0
Received 0 Likes
on
0 Posts
which position for the oil temp/pressure
hi ive seen two different positions for an oil temp/pressure guage locations. which one is best??
https://www.scoobynet.com/group-buys...ml#post8957831
OR
http://www.wrxtra.com/Documentation/doc-1004.pdf
thanks
steve
https://www.scoobynet.com/group-buys...ml#post8957831
OR
http://www.wrxtra.com/Documentation/doc-1004.pdf
thanks
steve
24 September 2009, 01:01 PM
#3
Both of them...!!
As they are two different sensors, you will need to use both. The first one is identifying the stock oil pressure sensor that you replace with the aftermarket one (you can use an adapter block to retain the stock one). The second location is a blanking boss on top of No. 3 Cylinder which is a good location for the Oil Temp sensor, as this cylinder tends to run the hottest.
Hope that helps.
As they are two different sensors, you will need to use both. The first one is identifying the stock oil pressure sensor that you replace with the aftermarket one (you can use an adapter block to retain the stock one). The second location is a blanking boss on top of No. 3 Cylinder which is a good location for the Oil Temp sensor, as this cylinder tends to run the hottest.
Hope that helps.
Thread
Thread Starter
Forum
Replies
Last Post