Fault code 13 (lamda sensor) (classic)
#1
Fault code 13 (lamda sensor) (classic)
would a de-cat and cone filter with out re-map cause this code to log?
it does tend to miss-fire alot at high revs, but not 'A' misfire, the car really holds back, as if boost cut? then takes off again.
any ideas?
it does tend to miss-fire alot at high revs, but not 'A' misfire, the car really holds back, as if boost cut? then takes off again.
any ideas?
#4
i had a similar problem on mine it was like a slight hesitation at partial throttle when it was mapped he turned the o2 sensor on and of <if possible> and it seemed to dissapear hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
General Technical
9
28 September 2015 09:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM