Going to attempt to fit my Nur Spec R few questions will i need any gaskets from centre section to downpipe also should there be a gasket between the centre and the back box? Also where is the best place to put the rear axle stands at? These questions have probably been answerd before but sorry im new to all this lol

 

The basket between your rear cat and the centre section should still be good, mine was on a 2001 bug when I changed to a Nur Spec 2 years ago. The car was on it's second exhaust then as it had a magnex fitted, and I re-used the gasket on my decat pipe.

My Nur Spec came with the gasket and bolts for the rear - centre section, so if it's new check the box, otherwise ebay will be you friend or any scooby specialist.

As for the rear axle stands, where the jacking point is at the rear of the sills, there is a 2" long section this sits proud on the inner sill, I use that for my axle stands

 

Not sure about the Axle stands but you will need a gasket between the centre pipe and the back box, and also between the centre and the downpipe (they should be in the box with the Spec R) If not, then youre have to get them in order to make a tight seal between the pipes.

The gaskets on my '05 were too worn and stuck to the pipes to re-use.

HTH's!

M.

 

If you need one from the cat to the centre pipe, this is the one you need

Subaru impreza turbo cat pipe-centre downpipe gasket on eBay, also, Subaru, Car Parts, Vehicle Parts Accessories (end time 27-Jun-09 19:37:41 BST)

And the other one you'll need is this one

Hks Exhaust Gasket 76mm/3 inch ID for Subaru Impreza on eBay, also, Subaru, Car Parts, Vehicle Parts Accessories (end time 13-Jul-09 19:20:05 BST)

 

Cheers for the advice i bought the Blitz seconhand with no bolts to join the centre section and back box so when can i get a pair from?

 

PM me your address and I'll throw some in the post for you

 

Cheers for that! Ill give fitting it a go next weekend then.

 

I'll get them in the post for you tomorrow

 

Hi guys,

ive just brought a Blitz Nur spec, for my p1.... its a second hand one but in mint condition, it hasnt come with any bolts will my existing bolts on my standard exhaust fit? if not where can i get these from?, i was thinking hayward and scott, but i decided to get the blitz hope ive made the right choice? ... im looking for a downpipe now, is there any particular one i should look out for, because some of them have a slot for a sensor does the p1 have this sensor :S ?

cheers

 

Cheers JonMC for those bolts its all up and running now sounds sweet!

 

You're welcome mate, glad to help