ADVICE ON PIPE'S WITH DIAGRAM
#1
ADVICE ON PIPE'S WITH DIAGRAM
Hi
i have changed the turbo inlet pipe on my00 and the pipe which goes from the inlet pipe to the standard dump valve is all spilt....
i have fiited a forge dump valve with the bung,
i was wondering if i could remove the complete pipe and just block the
inlet whole up?
its the red pipe on the diagram could i remove and block it up?
sorry about the poor effort of the diagram...
any advice is to be thanked
i have changed the turbo inlet pipe on my00 and the pipe which goes from the inlet pipe to the standard dump valve is all spilt....
i have fiited a forge dump valve with the bung,
i was wondering if i could remove the complete pipe and just block the
inlet whole up?
its the red pipe on the diagram could i remove and block it up?
sorry about the poor effort of the diagram...
any advice is to be thanked
#3
that red pipe can be bunged providing you have a dump valve to atmosphere and not recirculating.
the other connnection goes to the boost solenoid valve
and should have other for the breather system
hope this helps
matt
the other connnection goes to the boost solenoid valve
and should have other for the breather system
hope this helps
matt
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM