alanjack

I have read that the Oil to use is Motul V300 15/50.
But is there any paticular filter to use and how much oil would you put back in?
Regards Alan

SecretAgentMan

4.5 litres, and I've heard a rumour that one can find all sorts of rebadged filters in the OE boxes.

/J

alanjack

Is OE Original Equipment? and if so where would you get OE parts of the shelf?

Razor2001

4.5 litres for a JDM STi-7 or 5 litres ??

Cheers,
Ray

fivepint

@Alan, ur local Subaru dealer will supply an oil filter for ya, approx 10euros here in Dublin (including sump washer)

Cheers

MorayMackenzie

When changing the oil it may be worth fully priming the filter with fresh oil and, later, disconnecting the crank position sensor and turning the engine over on the starter to build oil pressure up ( until the oil pressure light goes out (~2 or 3psi iirc) at the very least ). Then reconnect the cps and start the car. I do this whenever I change my oil. It should help reduce the chance of a bearing failure shortly after the service.

Moray
bbs.22b.com