Cancelling "check engine light" 54 WRX STi
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Feb 2007
Location: Not far!!
Posts: 450
Likes: 0
Received 0 Likes
on
0 Posts
Cancelling "check engine light" 54 WRX STi
Hi guys. I have my check engine lamp showing on my STi. I have repaired the fault myself but cant cancel the lamp. I dont want to take it to the dealer as they charge a fortune for not alot of work!. I hear there is a method of connectors under the drivers side dash that can be connected to cancel the lamp? Any help would be gladly appreciated. Thanks guys
#2
Hi guys. I have my check engine lamp showing on my STi. I have repaired the fault myself but cant cancel the lamp. I dont want to take it to the dealer as they charge a fortune for not alot of work!. I hear there is a method of connectors under the drivers side dash that can be connected to cancel the lamp? Any help would be gladly appreciated. Thanks guys
#3
Scooby Regular
you cannot reset the CEL on the newage with under dash connectors, this is for the classic only.
however, the ecu should reset itself after 6 or so engine starts if the fault has been corrected. The fault will remain in the memory though until the fault code is read & removed by either a dealer or anyone with the correct software.
however, the ecu should reset itself after 6 or so engine starts if the fault has been corrected. The fault will remain in the memory though until the fault code is read & removed by either a dealer or anyone with the correct software.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM