Can anyone tell me exactly which pipe to clean for boost solonoid??


Pics would be excellent as I am a newbie to modding this engine!!

Would probably be ok if it had hair round it!!

 

All of 'em!

And the most important bit, the solenoid itself where I found most of the crap to be.

Your solenoid is a little cylinder thing mounted on your driver's side suspension strut.

Cheers
Rich

[Edited by RICH WILD - 2/22/2002 12:14:18 PM]

 

nice one think i know where u mean..

It has pipes going back to air box etc...

Is brake cleaner the best to use??

 

Brake cleaner or carburettor cleaner is best.

Cheers
Rich

 

im in the same boat here for an MY98

looking at the suspension strut there are 3 things attached to it.

at the back (two brass things with pipes) (poss steering?)

on the side next to the brake resevoir (poss Brakes?)

on the front between the air box and the suspension strut, brass cylinder with black plastic cap and about 3 other electrical connectors on the same bracket

1. which one is it????

2. how far do i strip it??

Pics would be of a great benefit as i am a mechanical biff

cheers
chris

[Edited by CHRIS_D - 2/23/2002 1:46:16 PM]

 

I think I should check mine too, anyone got pics?

 

Best to do this during a reset with all valves clicking on and off then using a spray force break cleaner through the valve but remember to pull the pipe to the waste gate off and let the cleaner drip to floor ....NOT onto a hot DP!!!

You will hear the valve clicking more cleanly if indeed it had crud in it.

Julian

 

Cheers for that matey..

Do I just remove pipes individuall whilst on tick over and then spray cleaner through or do pipes need all disconecting before start up??