AFR Target(for the mappers)
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Mar 2002
Location: Spec C - 12.5 @ 110(340/350)
Posts: 2,314
Likes: 0
Received 0 Likes
on
0 Posts
AFR Target(for the mappers)
Hi,
What's the accepted AFR targets to shoot for on V-Power for a JDM Twin Scroll engine? Anyone got a RR graph? I'm currently starting at 11+ at initial spool, then dipping down to ~10.3 at the red line. I'm about 20bhp/30lbft down on the ECUTek tune, I'm happy with my boost and timing curve, just wonder if shooting for high 10's will bring me closer.
I would just go out a log, but it's snowing, I'm bored and it'd be nice to know.
Cheers,
Paul
What's the accepted AFR targets to shoot for on V-Power for a JDM Twin Scroll engine? Anyone got a RR graph? I'm currently starting at 11+ at initial spool, then dipping down to ~10.3 at the red line. I'm about 20bhp/30lbft down on the ECUTek tune, I'm happy with my boost and timing curve, just wonder if shooting for high 10's will bring me closer.
I would just go out a log, but it's snowing, I'm bored and it'd be nice to know.
Cheers,
Paul
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Mar 2002
Location: Spec C - 12.5 @ 110(340/350)
Posts: 2,314
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Duncan, I did log Andy's maps pre-laptop blowup, I seem to remember the low boost map starting at low 11's and hitting high 10's, NF was mid 11's to low 11's, I think. I'll give them a try, thanks.
#5
Don't you often run a leaner than 11 AFR at spool to increase spool rate? Higher exhaust temps improve the spool. Running so rich down there seems a little pointless imho.
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
14
25 September 2015 02:33 PM