removing pistons from a p1
#1
removing pistons from a p1
hay you guys!!
just trying to fit two new pistons to the scoob, ive removed the inspection hole and cir-clip just cant get the bloody pin out.. any one got any little tips? i dont really wanna strip the sump and pull the rods to just change the pistons. any help would be great!!
mitch
just trying to fit two new pistons to the scoob, ive removed the inspection hole and cir-clip just cant get the bloody pin out.. any one got any little tips? i dont really wanna strip the sump and pull the rods to just change the pistons. any help would be great!!
mitch
#2
Scooby Regular
iTrader: (1)
Easiest way is to remove all 4 gudgeon pin access bungs, two 14mm's at the front on No.1 and 2 cylinders and two at the rear of the engine - one 14mm behind the oil seperator/breather plate on No.3 cylinder and the oval shaped plate on No.4 cylinder.
Use a long thin rod to knock the front two gudgeon pins out going from the rear and vice versa to do the rear gudgeon pins from the front.
ps - you wont get to all the rod caps from in the sump.
Mick
Use a long thin rod to knock the front two gudgeon pins out going from the rear and vice versa to do the rear gudgeon pins from the front.
ps - you wont get to all the rod caps from in the sump.
Mick
Thread
Thread Starter
Forum
Replies
Last Post