Help with manual boost fitting
#1
Scooby Regular
Thread Starter
Join Date: Sep 2008
Location: At Home
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Help with manual boost fitting
Hi guys. Was wondering if anyone has instructions on how to fit one??
pipes ? ?
Waste gate goes to boost solenoid - Do i need to install there??
As this picture shows. But it don't say anything about boost solenoid, do i reconnect back to boost solenoid or go to the bov ? If i have to go as per picture, what do i do about the pipe that goes to boost solenoid??
Any help/suggestions appreciated.
Thanks
Carl
pipes ? ?
Waste gate goes to boost solenoid - Do i need to install there??
As this picture shows. But it don't say anything about boost solenoid, do i reconnect back to boost solenoid or go to the bov ? If i have to go as per picture, what do i do about the pipe that goes to boost solenoid??
Any help/suggestions appreciated.
Thanks
Carl
#4
Scooby Regular
iTrader: (1)
Join Date: May 2006
Location: Going sideways is a way of life
Posts: 699
Likes: 0
Received 0 Likes
on
0 Posts
The manual boost controller replaces the boost solenoid so you just disconect all the pipes and follow the dig! But don't disconnect is as will bring up engine light!
Do you have a boost gauge to help set this up??
Do you have a boost gauge to help set this up??
#5
Scooby Regular
Thread Starter
Join Date: Sep 2008
Location: At Home
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Yes i have a boost gauge.
So how do i block the pipes that will be disconnected?? Is there some sort of special tool or can they just be tied back??
So how do i block the pipes that will be disconnected?? Is there some sort of special tool or can they just be tied back??
Trending Topics
#9
Scooby Regular
iTrader: (8)
Hi,
The diagram in you op is not the correct one for your car, a) the smaller pipe from the dv goes to 1 of the 3 ports on the inlet, ala b)you will only need the 2 pipes from the top and middle of the boost solenoid so it will look like this one when the MBC is fitted c) if you then disconnect the very bottom hose from the boost solenoid and thread a bolt or simular into it to prevent unmetered air being drawn in and just to be sure no **** gets pulled into the boost solenoid you can use a bit of hose to loop the top and middle port. Fitting guide for your car Hth
The diagram in you op is not the correct one for your car, a) the smaller pipe from the dv goes to 1 of the 3 ports on the inlet, ala b)you will only need the 2 pipes from the top and middle of the boost solenoid so it will look like this one when the MBC is fitted c) if you then disconnect the very bottom hose from the boost solenoid and thread a bolt or simular into it to prevent unmetered air being drawn in and just to be sure no **** gets pulled into the boost solenoid you can use a bit of hose to loop the top and middle port. Fitting guide for your car Hth
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM
bro82
General Technical
4
17 September 2015 07:41 AM