samcowrx

What size allen key is it for the pressure adjuster on the top of these things?, i think its between 4 and 5mm? iirc, so my thoughts are that it is imperial or 4.5mm which i do not have, i think the lock nut is imperial also but an 11mm spanner fits, any help appreciated, as i used a slotted screwdriver just to get it set to pre map 3bar.

tath

Not sure, but 3/16 is 4.7mm iirc.

tath

Durr, 'iirc' my ****. Calculate 25.4 / 16 * 3 = 4.76

Jay_

SX regs are all US made so are imperial.

The adaptor bolt is 3/16" hex and the locknut is 9/16" spanner. Think the bracket bolts and chamber bolts are all 9/64" hex. Worth getting a small set of imperial hex's basically .

Fai17

iTrader: (2)

Are these FPR any good?

tath

yes

kylejennings05

im going to fit mine soon, can you post a pic when done please?

samcowrx

This is on my car now, will get a pic of it in place tomorrow mate.

samcowrx

thanks for the reply about the imperial sizes mate, was what i thought then!

dunx

iTrader: (3)

I have a multi-bit set with a torx bit that fits ace !

And from my Hillman Imp days a selection of Imperial spanners....

DunxC