Fuel Pressure Sensor Position??
20 October 2008, 12:01 PM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Posts: 696
Likes: 0
Received 0 Likes
on
0 Posts
Fuel Pressure Sensor Position??
I'm wanting to fit my Defi fuel pressure sensor. Can I just remove the pressure guage which is on my FPReg, and screw in the Defi sensor there??
If this is the correct place is there any special procedures so I dont get covered in fuel?? I was hoping just to nip/clamp the main line in to the reg.
Any advice really appreciated.
If this is the correct place is there any special procedures so I dont get covered in fuel?? I was hoping just to nip/clamp the main line in to the reg.
Any advice really appreciated.
20 October 2008, 06:58 PM
#3
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
YES !
I put mine there !
There may be a little leakage, but wrap a rag round it and have the sensor ready to bung in, should o.k.
HTH
DunxC
I put mine there !
There may be a little leakage, but wrap a rag round it and have the sensor ready to bung in, should o.k.
HTH
DunxC
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM