I heard that rather than using a sandwich plate for the senders for these, the boxer engine has some free ports already built in and blanked off for this purpose ?

Has anyone got a pic of where they are at all ?

Its for a V4 STi engine.

 

temp goes into the blank above no3 pot using an adaptor from lemansautosport
pressure replaces the oe pressure under the alternator.
easy

 

may need and extension section for the pressure switch to clear the alternator

 

Thats what i did.The sender's to large to fit under the alternator,so fitted an LMA adaptor,works a treat If you look at my profile pic,it's the round silver thing on the front of the inlet manifold.

Mit

 

Is there any reason why people dont use a sandwich plate ?, The only thing I can see is it might bring the oil filter too close to the ground ?

 

Can anyone explain where the blanking plate above no.3 cylinder is, Ive had a look but it isnt immediately obvious ?

Or has some one got a pic ?

 

Have a look at this thread, in particular this post

https://www.scoobynet.com/group-buys...ml#post8046289

 

Thanks a lot James, much appreciated