I have an auto my95 wrx wagon,running tdo4. Mods are...walbro255,powertec induction,bell mouth decat & 3" jasma system,autobahn88 fmic,polar performance chip. Decat pipe and intercooler turbo pipe are heat wraped also a cold air feed pipe to air filter. I recently had it on the rollers, and it gave 240.2bhp 236ft/lbs i was hopeing for a little more is this a typical figure or is something not right, also AFR was just a shade rich on the top end but apparantly not really that bad.

 

are auto cars not a bit sketchy for getting flywheel figures from?

 

apparantly not just put in 3rd and use the hold switch which is what you use in icey conditions to stop it going up and down gears. It was 191whp by the way.

 

that is not too bad considering it is a td04 and on a generic map..

esl board and customer map is the next move

Simon

 

I have just full decat green pan filter, remaped at 240.8 and yes i was expecting 260+ it's a my00 with td04, was told turbo may be on the way out. JGM what turbo would you advise only looking for 280-300 horses.

td04
td05
vf34
vf35

cheers

 

simon is this board something that is fitted into my current ecu? what kind of price is the board and map by yourself of course and also what kind of power would you expect to be getting as its a healthy motor and turbo with 52k and exeptionaly well maintained,

 

vf34 is very nice.. but vf35,vf34 or td05 all do 300+

the td04 should achieve 265~280 depending on car

 

td04 should allow 265~280 depending on the car..

Simon

 

how much for you to fit the new board and map for me please Simon? as those figures sound much better.