bluenose172

iTrader: (2)

Does anyone have a guide or instructions handy for fitting the above? The new unit is a Forge unit.

bluenose172

iTrader: (2)

BTTT

gussy

iTrader: (2)

Bluenose its just unbolts off the turbo and the actuator arm is held in place with a spring c clip also pull the hose off which goes to your boost solenoid I cant remember if there is an adjuster nut but if there is just make the forge actuator rod the same lenght as the origional I will be taking my intercooler off this weekend so I will double check.

bluenose172

iTrader: (2)

Thanks Gussy, I take it it's an intercooler off job to access it.

gussy

iTrader: (2)

Yes to get decent access plus you will have to take the heatshield of from round the turbo its only 4 bolts and just lifts off.

Floyd

iTrader: (9)

I put an uprated TD actuator on my VF37 and its detailed on my project thread. Just make sure you are ready for the c clip to pop off as it'll ping quite far

bluenose172

iTrader: (2)

Cheers I'll have a look.

bluenose172

iTrader: (2)

Floyd - I can't find the post where you show how to install it. I can only see the pic of the one you bought.

Floyd

iTrader: (9)

Oh, I may have not written it up. It's very straight forward though. Simply unbolt the old one and remove the c clip. Make sure there is a bit of pre tension to hold it closed and the length is about right. Try opening the existing one to gauge the tension on that one first.