advice please
17 June 2008, 10:26 AM
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Mar 2008
Location: west mids
Posts: 984
Likes: 0
Received 0 Likes
on
0 Posts
advice please
i currently have a v5/6 uk turbo as it was 1 of the last classics it had the ae802 ecu which i have swaped for a ae801 i have up-ratted the fuel pump and it came standard with 440 injectors (even though it is a td04 turbo at the mo) it will when it goes for mapping (ecutek) have a cold air induction and a de-cat but i also have a vf22 from my old scoob which i would like to fit i dont mind the extra lag from the vf22 and am not after the 400+bhp you can get from it but how will if fair with a v5/6 top mount standard fuel rail ect.. on this setup is there anything else???
18 June 2008, 12:00 AM
#4
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Mar 2008
Location: west mids
Posts: 984
Likes: 0
Received 0 Likes
on
0 Posts
excellent simon just the man was thinking of you to poss map this car the turbo may not be a standard vf22 i have a pic of the turbo it has turbo dynamics on it and the actuator is not standard the up-pipe housing looks ported the inlet wheel has twin blades could it be a garret front wheel like a md195 poss???
Last edited by sy.; 18 June 2008 at 07:27 AM. Reason: spelling
18 June 2008, 04:33 PM
#7
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Mar 2008
Location: west mids
Posts: 984
Likes: 0
Received 0 Likes
on
0 Posts
spoke to TD who only serviced this turbo and 
it is a hybrid, it is a turbo
enterprise PE1820 HI RESPONCE???? built in japan i think?? anyone know anything about these?? anyone used or using one ???
it is a hybrid, it is a turboenterprise PE1820 HI RESPONCE???? built in japan i think?? anyone know anything about these?? anyone used or using one ???
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM