OBD light on/flashing! Please help
#1
Scooby Newbie
Thread Starter
iTrader: (2)
Join Date: Mar 2006
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
OBD light on/flashing! Please help
I have a 2004 sti, full de-cat system & ECU remap.
started the car yesterday all fine, got up the road OBD light came on, then started flashing and car started to labour really badly with no power. after a few mins the light stopped flashing, but stayed on, car felt normal again?
The car keeps going through this phase static light/flashing and labouring.
Can anyone please advise me of probable cause/solution to this?
after reading some other threads, could be the 02 sensor?
cheers guys.
Paul
started the car yesterday all fine, got up the road OBD light came on, then started flashing and car started to labour really badly with no power. after a few mins the light stopped flashing, but stayed on, car felt normal again?
The car keeps going through this phase static light/flashing and labouring.
Can anyone please advise me of probable cause/solution to this?
after reading some other threads, could be the 02 sensor?
cheers guys.
Paul
#5
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
see if they will reset the ecu.. this will clear all learnt data and if it is an issue related to exhaust it may run fine for a short time until it relearns unless it is det related in which case it will be instant.
Simon
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM