Fitting Apexi Boost Gauge.
#1
Scooby Regular
Thread Starter
Join Date: Feb 2004
Location: West Sussex
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Fitting Apexi Boost Gauge.
Im going to fit an Apexi Boost Gauge shortly on my my94.
I have a yellow and black wire on the gauge and just need to know what colour wires to connect to and location etc.
Im going to put the vacuum hose on the third pipe on the left is this ok?
Thanks
Dave
I have a yellow and black wire on the gauge and just need to know what colour wires to connect to and location etc.
Im going to put the vacuum hose on the third pipe on the left is this ok?
Thanks
Dave
#2
Scooby Regular
iTrader: (26)
As its a mechanical boost gauge, the only electrical requirements would be illumination that goes to the yellow wire, and the black is an earth.
Thats exactly how I would would wire it if I had it. As for location of the wire, you could either splice the illumination in the steerling cowling, or from the cigarette lighter.
Not sure about the boost pipe on your model/year.
Hope that helps.
Thats exactly how I would would wire it if I had it. As for location of the wire, you could either splice the illumination in the steerling cowling, or from the cigarette lighter.
Not sure about the boost pipe on your model/year.
Hope that helps.
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
1
17 September 2015 10:42 AM
bro82
General Technical
4
17 September 2015 07:41 AM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM