FORGED INTERNALS
Well a standard rebuild and refit when I needed one done a while ago was £2500. Of course after you've already paid the money, there are untold people who will helpfully tell you that they can get it done for £1500 by their mechanic friend. To hit 400bhp safely you will want a better build while you're there and looking at the cost of decent rods, pistons, bearings etc. it's got to be significantly more than £2500 for that sort of build?
Hi
Im doing just that as in a total rebuild using forged pistons n forged rods new bearings seals and gaskets uprated studs / bolts everywhere
also new water pump new oil pump n cam belt etc
and anything else i feel is needed
up 2 now its cost around £1400 in parts
not sure about any machining costs yet but prob around £100 - £150 for honing bores and refacing surfaces etc
my labour charges are free 2 me and in a mechanical tech n used 2 build racing spec motor bike engines so this is an easy build for me
i costed this out 2 a few engine builders who quoted any where between £1500 for a rebuild std engine 2 std spec or anwhere upto £5000 depends what spec u want which was resonable ish if your not mechanically capable
im doing this myself because ive got spare time and i think i can get a better spec cheaper because my time is free
regards Andy
Im doing just that as in a total rebuild using forged pistons n forged rods new bearings seals and gaskets uprated studs / bolts everywhere
also new water pump new oil pump n cam belt etc
and anything else i feel is needed
up 2 now its cost around £1400 in parts
not sure about any machining costs yet but prob around £100 - £150 for honing bores and refacing surfaces etc
my labour charges are free 2 me and in a mechanical tech n used 2 build racing spec motor bike engines so this is an easy build for me
i costed this out 2 a few engine builders who quoted any where between £1500 for a rebuild std engine 2 std spec or anwhere upto £5000 depends what spec u want which was resonable ish if your not mechanically capable
im doing this myself because ive got spare time and i think i can get a better spec cheaper because my time is free
regards Andy
ok thanks andy. im just wanting pistons, conrods etc. just so my car can handle around 340-350hp was hoping 2 go higher but as you would no got 2 change gearboxs and so on for higher power! cheers
Joined: Apr 2005
Posts: 11,778
Likes: 4
From: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Some 5 speeds don't like 290lb/ft, never mind anywhere near 400BHP. Well my old one didn't.
So like Steve say's, it would be wise to factor the cost of a better gearbox in also.
So like Steve say's, it would be wise to factor the cost of a better gearbox in also.
Trending Topics
Joined: Apr 2005
Posts: 11,778
Likes: 4
From: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM




