has anybody had there car mapped off andy forrest my car is booked in
and was just wondering if anybody has had cars done.

 

Lots of people have - he's one of the top Impreza mappers.

I've had my car mapped by him twice. Top bloke.

 

Yes. Me and loadsa other folk. He's highly respected.

When I took my car to a rolling road after mapping, the conversation between the operator and myself went along these lines :

RR Operator - "Well, whoever mapped this car knew what they were doing, the air/fuel ratio is spot on"

Me - "It was Andy F"

Op - "Ok, that explains it"

 

Scotsman : nice to see that you have been very thorough in listing all your car's mods in your plus profile -

Vf35

Parrott bluetooth handsfree kit

But which gives more power ?

 

Well know that the parrott gives at least another 18.5 bhp.

 

Had mine done on Friday by him liamAD, couldn't ask for a nicer more knowledgeable guy to do it...

 

well thanks alot guys looks like i have made the right choice, the car has a induction kit k and n 3inch turbo back exhaust, dump vavle and a apexi power fc and commander and getting custom mapped in ur opinion wot bhp do u think it could make. oh the car is a 1996 sti.

cheers

 

no need to worry if Andy is mapping your car

 

after the car has been mapped will i have to go elsewhere 2 find out the brake or could andy tell me?

 

Ecutek software which calculates bhp and torque, so Andy can give you an estimated figure at the time.

I should point out that Andy's figure was only 2bhp off the figure I got a few weeks later at Dastek !

 

thanks mate.

 

When you getting it mapped mate? Would like to know what figures you get as i have the same car and was thinking about going down the same route .

 

its getting it done on the 21st of december i will let u know.

 

Wrap up warm liamAD, the wind was bracing to say the least!

 

Cool mate cheers.

 

Get weighed the morning you go. Helps to know what weight the car is lugging for the bhp estimation!

great guy, i spent ages thinking i'd gone to the wrong place though, no signs outside!

5t

 

If Andy is mapping an Apexi power fc he wont be using ecutek, so wont be able to use that to estimate the bhp / torque. Although i would reckon he would have a good idea just from driving it and how it feels.

 

or take it for a power run on a dyno after your mapping

 

does anybody know if andy could supply me with the anti lag and launch control with this ecu.

 

Not with a power FC mate

 

for that you would need motec, simtec or similar

 

The Apexi Power FC can be mapped to give a degree of pops and bangs with the odd flame on overrun but not full anti-lag.

Andy

 

ah ok thanks mate for the info.

 

our kid got this on his and its an absolute hoooot





as long as its not your car