ok where is the best place to go for a remap i am in the (south) buckinghamshere i have a full decat green panel fiter dv / it is a 1999 uk2000
i have been on the rollers and got 280bhp 269t at powereingering so will a remap give me moore / i am only the 2 owner of the car and it has not had a remap / i think i have a td04 wich is good for 300bhp i think

 

You are not too far from Bob Rawle then, who is an excellent mapper.
0208 332 7534 or info@brdevelopments.com
I suggest giving him a call and seeing what your best options are.

 

Unless you have a bigger turbo, no point in a remap as far as I can see (apart from piece of mind of course) as they are fantastic figures with a remap, let alone without!?!

Are you sure it hasn't been remapped?

My UK Turbo MY00 produced 230bhp before remapping, and 273bhp/273lbft after.

With the following mods:

JR Panel filter
Ninja Sports Cat dpipe
Magnex centre and backbox
3 port boost solenoid.

270-280 is the norm with exhaust mods and a remap on the TD04.

300 I believe is possible with the TD04 (I read a thread a long time ago about someone who had done this) - but you have a long list of the best accompanying mods to get this and a lot of luck IMO!

 

agree.. sounds like it has been mapped already

Simon

 

Either that or one very very generous set of rollers.

Map will give you proper 'on road' performance and a much more accurate power figure (assuming it hasn't been done already)

5t.

 

i hade a nice chat with the other owner he waz in his 60 when i said did he
mod the car he said wot is modifie lol / so as far as i no it has not had a remap i get 15psi on full boost

 

sounds like a good car then

 

Blinking eck!

279bhp @ 1bar when my very similar car achieves 273bhp @ 1.25bar and without a remap??

Very confused

As I said earlier, after I changed exhaust/filter/clutch/MAF etc. etc. I drove to Powerstation.

They RRed it before mapping - 230, and after 273

Anyone own it before the 60yr old bloke

 

nop i am the 2 owner /15psi mite be out as my bosst gauge is crap need a new 1

 

If it hasn't been remapped then its near enough correct - I think standard peak boost is 0.9bar.

You must have a freak machine - get it remapped!!

Unless Power Engineering's rollers were way out, and I can't see that happening really?

 

PE rollers are generous compared to dyno dynamics but not that much!