Jacking / Axle stand points MY03
#1
Jacking / Axle stand points MY03
Hi,
Hopefully an easy question, I want to rotate the tyres on my WRX and would like to do it in one go rather than jack up a corner and use the spare. Can anybody tell me where the best place to lift the car is front and back using a trolley jack and also would it be possible to put it onto axle stands?
Thanks in advance.
Hopefully an easy question, I want to rotate the tyres on my WRX and would like to do it in one go rather than jack up a corner and use the spare. Can anybody tell me where the best place to lift the car is front and back using a trolley jack and also would it be possible to put it onto axle stands?
Thanks in advance.
#2
Scooby Regular
iTrader: (1)
Join Date: Oct 2004
Location: Half way up
Posts: 4,791
Likes: 0
Received 0 Likes
on
0 Posts
You should just be able to get both front and rear off if you jack up high enough at the front jacking point (sill seam just behind front wheels). See owners manual.
Best using a decent trolley jack and support with stands for safety. Also ensure handbrake is on fully, engage 1st/reverse gear and chock other side..!
Best using a decent trolley jack and support with stands for safety. Also ensure handbrake is on fully, engage 1st/reverse gear and chock other side..!
#3
Thanks for the reply jasonius.
I found this on the net, which I hope helps others.
Subaru Impreza Jacking Points
I found this on the net, which I hope helps others.
Subaru Impreza Jacking Points
Last edited by Vonzack; 31 August 2007 at 09:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM