SSCJAY

Am Putting a 2.5L bottom end on my 2.0L and after reading a few posts think it is advisable to get the squish area of the heads to match the new diameter bore of the 2.5L block.

Can anyone advise where I can get this done (professionally) & approximate cost.

Many thanks

bluerigster

iTrader: (9)

Roger Clark Motorsport carry out the chamber conversion for 225 pounds plus VAT.

SSCJAY

BTTT

Any body else had this done? Where From?

I thought 225 + VAT per cylinder head was a tad expensive,