NEED HELP. Does anyone know how to bleed this hydraulic pipe bender???
#1
NEED HELP. Does anyone know how to bleed this hydraulic pipe bender???
Ive hired this pipe bender to fabricate my roll cage over the weekend but i just carnt get it to work and tomorrow is my last day off, im really pis*ed off. The place i hired it from are closed and there are no instructions, its meant to be back tuesday and ive been messing about trying to get it to work for hours.
does anyone know how to get it working? there is a cap that screws off ond a few bolts on it but i havnt a clue what they do.
thanks for any help james
does anyone know how to get it working? there is a cap that screws off ond a few bolts on it but i havnt a clue what they do.
thanks for any help james
#2
Scooby Regular
iTrader: (1)
Join Date: Apr 2007
Location: Up-North Like!
Posts: 1,266
Likes: 0
Received 0 Likes
on
0 Posts
Not sure about the others
The pressure relief screw should be turn completely in/tight/clockwise and it should simply jack up. If it needs primed normally pump the handle with the pressure relief screw open a few times, then tighten it and jack it up, loosen it and push it shut. Repeat that several times untill it is fully primed/bled.
Hope that helps.
The pressure relief screw should be turn completely in/tight/clockwise and it should simply jack up. If it needs primed normally pump the handle with the pressure relief screw open a few times, then tighten it and jack it up, loosen it and push it shut. Repeat that several times untill it is fully primed/bled.
Hope that helps.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM