alternative to the standard turbo elbow?
17 April 2007, 03:02 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: Manchester ish
Posts: 18,547
Likes: 0
Received 0 Likes
on
0 Posts
alternative to the standard turbo elbow?
As per title is there an alternative to the standard black plastic elbow that goes from the turbo to the maf/induction? as my dumpvalve take off has sort of seperated so its causing a bit of an air leak. 
The car is a 93wrx btw
The car is a 93wrx btw
17 April 2007, 05:37 PM
#2
Scooby Regular
iTrader: (2)
Join Date: May 2000
Location: Class record holder at Pembrey Llandow Goodwood MIRA Hethel Blyton Curborough Lydden and Snetterton
Posts: 8,626
Likes: 0
Received 0 Likes
on
0 Posts
Depends if you want to reroute breathers etc?
I did it DIY
22B Bulletin Board: A theory to help cure lift off judder caused by FMIC / MAF / recirc DV combo
If you're using the OE dumpvalve pipework I think you'll need a 19mm elbow instead of the 25mm one I used.
I did it DIY
22B Bulletin Board: A theory to help cure lift off judder caused by FMIC / MAF / recirc DV combo
If you're using the OE dumpvalve pipework I think you'll need a 19mm elbow instead of the 25mm one I used.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
charlesr
Engine Management and ECU Remapping
7
26 September 2015 10:46 AM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM