How much wrap will I need for just the standard headers on my classic? 1"x50'? 2"x50'? 1"x100'? And anyone got any pictures of wrapped headers? Cheers!

 

yes 50 meters is just short

the DEI stuff is really good , I also used the DEI ties which are a bit expensive

i got mine form Nimbus Motorsport - motor racing thermal control products, specialist lubricants, professional clothing, equipment who i would highly recommend

 

Nice Job mate

How did you get away with so few ties?

 

at £12 for 4 its easy

i did use more after the photo and used some jubilee clips on the up pipe

 

Which width? 1" or 2"?

 

im sure that was 2 inch

 

hey rich I cut my finger yesterday. I should have got u to dress it

 

And presumably it's ok to overwrap two pipes together like that then? I had always assumed every individual pipe had to be wrapped separately, but I suppose in that case the pipes are too close together?

 

http://i132.photobucket.com/albums/q...k/DSCF0275.jpg
http://i132.photobucket.com/albums/q...k/DSCF0274.jpg
http://i132.photobucket.com/albums/q...k/DSCF0273.jpg
http://i132.photobucket.com/albums/q...k/DSCF0278.jpg
http://i132.photobucket.com/albums/q...k/DSCF0277.jpg

 

Very tidy!

 

the reason why i wrapped 2 together was to get as hot as possible

 

Ah, I see. Cheers!

 

On O/E headers with the lugs cut off and dressed, using DEI 2"X50', headers and aftermarket up-pipe takes one roll.
The DEI has stitching 6mm or so from the edge so you get the overlap right.
Read and follow the instructions.
Subject to header material, double wrapping may lead to problems.