AVCR boost setup on Classic WRX
04 October 2006, 09:57 PM
#1
AVCR boost setup on Classic WRX
Hello,
I am finally getting round to fitting my AVCR to my MY98 WRX.
Its mapped by AndyF to 1.25 bar but I am taking it to 1.4 midrange and then tailing off at the top.
This is what I would like to know. AT what rpm should I be reducing the boost back down to 1.25? I have the rev limit at 7.3k, but never really go above 6.5k.
I spoke to Andy a while back to see if 1.4 was doable and he said yes, but I forgot to ask at what RPM to reduce.
Cheers,
Wayne.
I am finally getting round to fitting my AVCR to my MY98 WRX.
Its mapped by AndyF to 1.25 bar but I am taking it to 1.4 midrange and then tailing off at the top.
This is what I would like to know. AT what rpm should I be reducing the boost back down to 1.25? I have the rev limit at 7.3k, but never really go above 6.5k.
I spoke to Andy a while back to see if 1.4 was doable and he said yes, but I forgot to ask at what RPM to reduce.
Cheers,
Wayne.
05 October 2006, 10:08 AM
#3
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
I would be suprized unless Andy mapped it to higher boost and then dropped it afterwards that Andy would suggest you just up the boost without him checking it / setting it up.
I know what rpm I would drop the boost back down at etc.. but it is pointless me suggesting that as I didn't map it.. I would suggest you contact Andy and get him to set the boost up and check the fuelling and ignition at the new boost level.
Simon
I know what rpm I would drop the boost back down at etc.. but it is pointless me suggesting that as I didn't map it.. I would suggest you contact Andy and get him to set the boost up and check the fuelling and ignition at the new boost level.
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM
